Connector detailed Guide

Comments

  1. 文王廷Tuesday, August 10, 2010 at 1:01:00 PM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete
  2. AnonymousFriday, August 13, 2010 at 3:05:00 AM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete
  3. 于庭吳Sunday, August 15, 2010 at 6:58:00 AM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete
  4. AnonymousTuesday, August 17, 2010 at 10:01:00 AM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete
  5. AnonymousThursday, August 19, 2010 at 3:23:00 PM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete
  6. AnonymousSunday, August 22, 2010 at 7:18:00 AM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete
  7. AnonymousSaturday, September 7, 2013 at 1:33:00 AM GMT+5:30

    This comment has been removed by a blog administrator.

    ReplyDelete

Post a Comment

Popular posts from this blog

MODE CONDITIONING PATCH CABLE-Fiber Optics

Image
Optic Fiber Mismatch - Solution is Mode Conditioning-Which Can go Maximum of 770 Meters  (Converter Plays vital role- Please check with vendor)   A mode conditioning patch cord is a special  fiber patch   cable  that combines multimode fiber cable and single mode fiber cable with calibration. It is a duplex multimode fiber patch cord constructed with a length of single mode to multimode offset fiber connection part at the start of one of the two legs. Mode conditioning patch cables are 62.5/125µm or 50/125µm fiber cables assembled with fiber connectors on both ends, such as LC-LC, LC-SC, SC-ST, etc. 
Read more

SIL assignment

SIL Notes Objective : SIL assignment establishes the risk reduction needed for each                     process system to protect against one or more hazards,                      The risk reduction is calculated as the gap between the existing risk posed by the                          process or  equipment and the risk target.                     Risk reduction (Layer of Protection) is provided by process and mechanical                                  integrity, Independent Protection Layers (IPLs) and required Safety Instrumented                      Systems (SIS). Scope :  The SIL level of each...
Read more